Properly installed foam improves humidity control by sealing air leaks. Improper application (especially mixing closed-cell and open-cell incorrectly, or sealing without ventilation) can cause issues. Every project here is designed with the home’s ventilation strategy in mind.
More detail
Columbus summer dew points sit in the mid-to-high 60s for stretches at a time. Air leakage during humid weather brings outdoor moisture into the conditioned envelope, where the AC has to remove it (latent cooling load). Foam reduces that air leakage, which typically improves indoor humidity control. Columbus sits in EPA Radon Zone 1, so any post-foam home above 4 pCi/L should plan for an active sub-slab depressurization radon system sized for the tighter envelope. The rare cases where foam creates humidity problems: (1) tight foam install without mechanical ventilation; the home becomes too tight, indoor moisture from cooking, showering, and breathing accumulates. Solution: install an ERV (energy recovery ventilator) sized to the home (typically $2,500-$5,000 retrofit). (2) Cold-roof-deck condensation when open-cell foam is sprayed on a roof deck without proper vapor management; this risk is higher in Columbus Zone 5A than in zones to the south because the roof deck runs colder in winter, so closed-cell is the default at the deck. (3) Pre-existing moisture issues that foam encapsulates rather than resolves; moisture sources are identified and remediated before spraying. Columbus ventilation-pairing recommendation: any whole-home foam project that brings post-install ACH50 below 5 should include an HRV or ERV. The Columbus-area norm is to pair the ventilation install with the foam work as a single closeout package; doing both at the same time runs $2,500-$5,000 for the ventilation upgrade and avoids return visits later when air-quality concerns surface.